Your browser version is outdated. We recommend that you update your browser to the latest version.

 UpComing Event

1.Phinken Parent's Training

Date : 30/6/2018

Time:11.30am-5.00pm

Venue:  Cube 4, Level 3, Isetan, The Japan Store, Lot 10, Kuala Lumpur

 


New Arrivals

Follow us on WechatFollow us on Wechat

STEM Affiliation PartnerSTEM Affiliation Partner

BRAInet AdvisorBRAInet Advisor

Tips and Tricks for Model Building

1. Use the "A" end of the axle/peg remover to pull off the peg (Fig. 16).1. Use the "A" end of the axle/peg remover to pull off the peg (Fig. 16).

2. Use the "B" end of the axle/peg remover to pull off the peg (Fig. 17).2. Use the "B" end of the axle/peg remover to pull off the peg (Fig. 17).

3. Use the "B" end of the axle/peg remover to pull off the peg (Fig. 18).3. Use the "B" end of the axle/peg remover to pull off the peg (Fig. 18).

  

How To Remove Battery

Use the "B" end of peg/axle remover to remove the battery out of the holder (Fig. 22).Use the "B" end of peg/axle remover to remove the battery out of the holder (Fig. 22).

 

Fig.19 

 

 

4. When attaching a gear or a tire to the framework with a drive axle, be sure to keep a gap of about 1 mm between the gear or the tire and the framework to decrease the friction caused in operation so that smooth motion can be assured (Fig. 19).

Fig.19 

How to assemble and disassemble Tube Support and Tube

Note: Be careful when you insert each piece as fingers may be pinched (Fig. 20).

Push the tube support into tube and turn the tube until a "click" is heard (Fig. 20).

 

 

 

 

 

 Put release pliers into holes that have safety lock pins coming through and squueze the pliers to release the tube from the support (Fig. 21).

How to change the Lithium Rechargeable Battery (LIR2032)

1. This battery should be changed only when it becomes weak, after 500 loadings at least.

2. The operation must be done by an adult.

1. Put the battery in the battery holder.1. Put the battery in the battery holder.

2. Push down the battery2. Push down the battery

3. It fixes with a snap3. It fixes with a snap

How to take out the Lithium Battery

1. Remove the four screws with a small screwdriver (not included)1. Remove the four screws with a small screwdriver (not included)

2. Open case2. Open case

3. Depress metal clip3. Depress metal clip

4. Remove and replace battery4. Remove and replace battery